Separate names with a comma.
Some features disabled for guests. Register Today.
It's been a little over three years since my build and I've finally modified my printer for dual direct drive. I'm happy with the results so far,...
Check out matterhackers.com for their take on E3D heatbreaks (Clean Tip $24)or their replacement E3D heatbreaks are listed for $20. I've bent a...
I've been using a product called Buildtak. Is that similar to PEI? I'm really impressed with it. It's made part adhesion one less thing to worry...
Put me down for #2. The only reason I don't chamfer something is because I've already filleted it. :)
I learned from the best! :)
Here's mine using a handycam (6hrs) to After Effects using Timewarp. [MEDIA]
Ditto on the support assist. Here's my go at this Eric's model. [ATTACH] I'm just at the tricky part (head and antlers). We'll see how it...
Thanks for all the great info this forum is generating. I'm hoping to go direct drive soon as well, but I need to work out my fundamentals first....
This is the case: http://www.thingiverse.com/thing:87250 These are the braces I used to work with the V-Rails:...
Good eye Eric, I got the fan type from one of your previous posts. ;)
Yes, lots of support. I printed it on my Up! Plus2, on its back with the edge of duct touching the bed. I'm having problems with first layer...
Here's a couple photos of my build to date. A lot more calibrating to be done. Currently using two V6 with .4mm nozzles. Once I get everything...
I wanted to add a couple mods I'm working on. I started by attaching my X Endstop to the back of the carriage and added a threaded rod to the X...
I've gotten my printer going and in the process of calibrating, I started running into a situation with my electronics. I'm using a Geeetech Rumba...
Here's the Printer and the Torture Test file I ran. [ATTACH] [ATTACH] The Torture Test did not complete. It was at 97% when the firmware...
