Separate names with a comma.
Some features disabled for guests. Register Today.
Here's my Hot Wire Foam Cutter now with updated software and firmware. Full details are on my website as well as an eBook with plans,...
2021 Sept Update I hadn't been using my CNC Router very much mainly because the CNC foam cutter had kept me very busy. My 3d printer is used for...
This is a new build of a USB version of CNC hot wire foam cutter using 3d printer electronics? The picture below shows my latest RC models I’ve...
Thanks, Mark been a fun project to do with many more planes on my to-do list
rcKeith published a new build: Build a Hot Wire CNC Foam Cutter with inexpensive 3d printer electronics. Read more about this build...
Glad to help out. Software isn't as readily available for 4 axis CNC foam cutters without spending a fair bit of cash. I should know I did that...
You’ve built your 4 axis CNC Foam Cutter and now you need some software to generate g-code for that foam wing. If you can afford it then buying...
Hi David Can I do a manual zero of the Z axis once its done a move to the tool change area. I tend to use CNCnutz (Peter Passuello) method...
Thanks David that very thorough. I'm using Mach3 so I believe that works OK. I'll give it a try over the weekend. I'm trying to make some...
Been using sketchucam for a little while and seen the option when you save the parameters for tool change Not to sure how it works and wondered...