Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks for the help. Will do.
Thank you. I have already placed my order, but didn't notice that my delivery address was incorrect. I immediately went and changed my address...
Ah, Found it. T-nuts. Simple. Duncan
Hi, Thank you for the examples. They are very helpful. However, neither of them show how to attach the upright to the gantry plate. All I can...
Hi, hotwires don't require large stepper motors, so I'll use the small ones. And the LA bundles are belt driven. Anyone able to offer some...
Hi, I am wanting to build a simple hotwire system with two 1.5m linear actuator bundle as the bases, and two 500mm actuators making up the two...
Hi Sonny, I am wanting to build a CNC Hotwire, using four V-Slot Linear Actuator bundles. Two of these will be fixed to the table base. The...
Hi, Is there a practical limit to the length of the belts? I'd like an X-axis of 1000mm (or close to it). Is this too long for a 2mm belt? If I...
Hi, I am in Brisbane, Australia. I understand that you have a distribution centre in Perth. However, when I used your shopping cart to estimate...
Hi, In the description for all three of your CNC USB controllers you say: "stepper motor drivers will be needed to run the motors" Where do I get...
Hi, You list three CNC USB boards (CNC USB Controller, CNC USB Controller Mk 2/4 and the CNC USB Controller Mk2 (9 axis) but it is not clear what...
