Separate names with a comma.
Some features disabled for guests. Register Today.
Not sure about the plates, but I glued down a spoil board that is slightly smaller than the max working area of my router. Then you can face the...
I think I have found the problem, I had a cheap chinese water pump for cooling my spindle that came with it. Turns out if I unplug it, I only get...
OK cool. It is all mounted in a proper electrical cabinet but I will check all the grounds.
Thanks Gary, I will try and eliminate all those things and see if they help. My spindle cable is shielded, but not my steppers. I have the control...
Hi Guys! I have had my sphinx router for a while now, It is set up with BCNC and a Phoenix cnc controller (Arduino). All along I have had an issue...
Second what Scotty said, use it to spot your holes etc, then drill out on the drill press, then cut none critical geometry by hand. If you are...
I probably wouldn't go straight to aluminum from mdf. Its just not stiff enough.
Hi Guys! Welcome to my Sphinx with a twist build. I have the design in my head, and somewhat in CAD but hopefully I will finalize it in CAD once...
Haha, Hayri just sent me a link to that driver, I installed it and everything worked perfectly. Thanks Kyo! I learnt a lot I probably didn't need...
Thanks! I also have a plan for a "vice" built into the front to clamp larger or odd shaped parts. I have just tried out 2.7 and 2.7 to see what...
Thanks Kyo! I have posted a lot of my build so far. I am in touch with Hayri right now, trying to figure it out. I am running Python 3.3 and...
So close to getting my build done and running, just cant get bCNC to connect to the phoenix cnc controller. It simply wont show up in the serial...
