Recent Content by Serhioormano

Post

I was investigating it and I found out that for plasma timing belt is ok. I'll use G3. It will be even good for router on wood and plastic. I do...

Post by: Serhioormano, Apr 7, 2015 in forum: Other Builds

Post

I see. The boards have to be names like 3-motor or 4-motor control board. I was confused by terminology that this is 4-AXIS board and I was not...

Post by: Serhioormano, Mar 26, 2015 in forum: Controller Boards

Post

What controller did you use?

Post by: Serhioormano, Mar 25, 2015 in forum: CNC Mills/Routers

Thread

I got little bit lost here. I am building plasma cutter. Actually by definition it is even 2.5 axes. But ok, let's say it is 3 axes because i have...

Thread by: Serhioormano, Mar 25, 2015, 6 replies, in forum: Controller Boards

Thread

I am building CNC Plasma Cuter. But it looks like here there is no section dedicated for that. Is that because it is not suitable? I want to use...

Thread by: Serhioormano, Mar 24, 2015, 3 replies, in forum: Other Builds