Separate names with a comma.
Some features disabled for guests. Register Today.
I used a model airplane CA hinge and it only needs a gap of 1-2 mm.
I got your message and sent a reply.:)
I know many folks have all the metal parts to build this fun little machine. If you are in need of the 3D printed parts used, them message me and...
I think they build them in house. Drop them a line and see if they have just the wires available.
In that case. Look at these. Its what I use on my 23s. CNC Motor Cable | CNCRouterParts
What motors? 23...17? I run heavy gauge (22) servo wire for my 17s. Its rated at 7amps over 100'...
1 z motor would work fine depending on the size and weight of your x carriage and beam. Mine is about 470 mm long and I will eventually run duel...
Here are some pictures of the print quality for those wondering what this design is capable of. I had to twist the drive belts at the idler end of...
They still make laptops that pull from the bottom??.....oh yeah....apple.;)
They have parts over on amazon as well. When they were closed for the two long holiday weekends I had to order some couplers in order to get them...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Hope its ok, but I decided to share some pictures and changes I...
Some aluminum spacers have the exact same ID and OD as the shim. If you dont need the extra space provided by the shim, then as long as the spacer...
In that specific case you would want to bridge the gap of the slot. Openbuilds sells specific washers for this. The precision shim wont...
For me, the shims act as a spacer between any surface and the bearing. I use shims on all my bearing applications to transfer the compression load...
Orlando?!!!!....cooled off?!!... what, did it cool down to 60? ;) Woke up Saturday morning to a dead battery in my truck do to a 3 degree...
