Separate names with a comma.
Some features disabled for guests. Register Today.
I have two machines, one regular 3-axis that is an OX which is 24" x 40", and one a rotary OX that is 8" x 36". I had absolutely no issues with...
After a great start, high expectations and a lot of time, I gave up on GRBL. Too many issues, too many things it just doesn't do, too many things...
You really should bolt the two beams in the middle, whether you flip one or not. When the Z-axis carriage approaches the middle, the torque on the...
I didn't even catch that.
One way I have seen to successfully cut really thin material is to sandwich it between two thicker pieces. You may want to try cutting it in...
Have you calibrated your machine so it is moving the actual distances the software thinks the axes are moving? It usually has to do with steps per...
I've pretty much given up on GRBL and can't get any of the Chinese boards to work to my satisfaction with Mach3. Now, I'm looking for another...
Yes, the green LED is the one I'm referring to. The color varies, I have green, red and yellow. The voltage you measured is well within tolerance....
Could be a wiring issue, a bad motor or any number of things. if that's the case, a new thermistor should fix it. You don't have to hook anything...
I can almost guarantee the thermistor will blow if you replace it. Something is overloading the supply or there is a bad component. The ones at...
Hook the Uno up to your PC and boot the Arduino IDE. Set the correct COM port. Go into TOOLS>Serial Monitor. Type in $RST=$ That should do it.
I had one like this. I replaced the thermistor twice and the fuse twice. Finally out of desperation, I shorted the fuse with a piece of wire. It...
I can't speak for others, but I put all of my electronics in an old PC case. I also have a dust collection boot that collects 95% of the dust....
I'm afraid I'm not going to be much help. I tried modifying the config.h file as discussed in this FAQ: Homing with 2 Axis Machine · Issue #224 ·...
Yes, save the file in wordpad. Once you have made all the changes that you want to all of the associated files, you have to compile GRBL in the...
