Recent Content by TheManWithNoUserName

Post

Hi Bob, Thanks for the speedy reply. So, I see in config.h, the section defining homing patterns. From the (very well written) comments, it seems...

Post by: TheManWithNoUserName, Aug 26, 2016 in forum: CNC Mills/Routers

Thread

Hi all, My apologies if this has been asked before. A quick search didn't show anything. I have a XPro CNC driver. I'm only wanting to use a...

Thread by: TheManWithNoUserName, Aug 26, 2016, 2 replies, in forum: CNC Mills/Routers

Post

Hi Gerald, Thanks for the reply. I tried the current adjustment pot for the motor axis (I'm only using the Z at the moment) and also different...

Post by: TheManWithNoUserName, Jun 12, 2015 in forum: Controller Boards

Post

Bump? Anyone??? Please??? I've downloaded the drivers for the Ft232 UART chip used on the XPro. It responds to the ? command to obtain the current...

Post by: TheManWithNoUserName, Jun 11, 2015 in forum: Controller Boards

Thread

Hi all, I'm trying to get the xPRO Controller to run using LabView. I need to use LabView for the project which is making measurements on an...

Thread by: TheManWithNoUserName, May 27, 2015, 3 replies, in forum: Controller Boards