Separate names with a comma.
Some features disabled for guests. Register Today.
How did this project turn out?
I'd like to add a 4th axis to my XCarve. I need to build a new controller system to do that. This board will go a long way towards that end. I...
Here's the workbench I'm building. How to Make the Ultimate Garage Workbench ยป Curbly | DIY Design & Decor Downloadable PDF plans and all.
The lead screw, bearings, nut block, and backlash would all be on the front side closest to the Z-axis carriage. For the ends, an L-bracket across...
@Metalguru @Moag Another alternative is to spin the vertical risers 180, add a second Cbeam to the gantry, and spin the X-axis Cbeam 180. See...
Nice bench. Looks extremely sturdy, perhaps more than you'll need. I'm actually in the process of designing and building one myself. For the C...
@Moag Could the two X-axis 'feet' be replaced with 20x40 instead of the 20x60 sized rails? As you know ;) I've taken a very good look at the...
Couldn't you just make the board bigger? (edit) Never mind. I get it now. It just took me a few minutes to process. I suppose the only way to...
@Moag - Why not move the gantry to the backside of the vertical sides as shown in the following pic? You would have to relocate the additional...
This build looks absolutely fantastic. The build instructions are superb. This is on my Christmas wish list and my wife will have all the links...
Feirie - (Scottish for nimble, strong)
Cogent Pro - (not currently trademarked)
DaisyCutter
CNCDirector
CNCcommander
