Separate names with a comma.
Some features disabled for guests. Register Today.
spauda01 here Saw your 3-27 video, hooray for stock config :D You're right about not leaving enough room in the control box for lcd adapter, I...
Glad you like the D-bot remix, I'll probably stop by and check out the build.
On the RepRap forums, they have a section called machines organized by name. Under each printer name, there is a page with subtopics based on that...
You totally can and should PID tune your bed like it shows in the Dbot instructions. You can't PID tune if you use bang mode or a mechanical relay...
Did you hook up the output backwards? your load will power on regardless of control signal if you connect the output backwards
Solid state relays have no moving parts either. The main cause of them burning up is improper heatsinking. Conveniently, this printer is made up...
They are running in spreadcycle mode, not stealthchop
[MEDIA] They run better at 24v input to the stepper drivers, there is still a slight high pitch noise when the motors are stationary but overall...
[MEDIA] Hold on to your money for now. Initial results are worse than my generic A4988s, when the motors are running and stationary. The only...
thanks, any ideas for improvement are always welcome too
This stuff works pretty well - http://www.amazon.com/gp/product/B00U8LA25O?psc=1&redirect=true&ref_=oh_aui_detailpage_o03_s00
One of the simplest and cleanest ways to manage wiring to the print head is just bundle wiring and bowden tube in a piece of black plastic tubing,...
I recently bought three to try on the X,Y and E drivers, been too busy to test them out but I'll share results when I do. At $13 a piece I hope...
I've been noticing that cooling from one side leads to quality issues on the side opposite the duct. Would your duct work for an e3d v6? I'm...
Looks like you mounted your solid state relay to plexiglass, one way to help avoid potential overheating in the relay is to mount it directly to...
