Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Recent Content by woofguy

  1. woofguy
    Post

    Question about RAMPS 1.4 boards

    thanks to you as well Mon!
    Post by: woofguy, Dec 19, 2016 in forum: CNC Mills/Routers
  2. woofguy
    Post

    Question about RAMPS 1.4 boards

    Thanks Justin, that was it!
    Post by: woofguy, Dec 18, 2016 in forum: CNC Mills/Routers
  3. woofguy
    Post

    Question about RAMPS 1.4 boards

    also the black board from my printer is fine!
    Post by: woofguy, Dec 18, 2016 in forum: CNC Mills/Routers
  4. woofguy
    Post

    Question about RAMPS 1.4 boards

    Thanks, and yes i did have it RED/BLACK/RED/BLACK. I also ran to radioshack and got a pack of diodes, replaced the bad one and it popped again?!...
    Post by: woofguy, Dec 18, 2016 in forum: CNC Mills/Routers
  5. woofguy
    Post

    Question about RAMPS 1.4 boards

    thanks 3dmon, so based on the images above, going from left to right on the green connector, is it RED/BLACK/RED/BLACK or is it BLACK/RED/BLACK/RED?
    Post by: woofguy, Dec 18, 2016 in forum: CNC Mills/Routers
  6. woofguy
    Thread

    Question about RAMPS 1.4 boards

    Hello all, please forgive if this has been asked, I searched and couldn't find anything similar to the issue I am having. I started my quest to...
    Thread by: woofguy, Dec 17, 2016, 9 replies, in forum: CNC Mills/Routers
  7. woofguy
    Post

    GRBL Shield help.

    so attached is a wiring diagram for my spindle, i assume the "mach 3" connection is pwm?[ATTACH]
    Post by: woofguy, Dec 10, 2016 in forum: Controller Boards
  8. woofguy
    Thread

    GRBL Shield help.

    Hi All, After months of debate, I finally picked a project and started building my first CNC machine. I selected the Root 2 CNC Root 2 CNC...
    Thread by: woofguy, Dec 8, 2016, 5 replies, in forum: Controller Boards
  9. woofguy
    Thread

    Small inexpensive CNC

    Hi all, just joined today. im looking to make a small (like 8x8 or 12x12) CNC router. being able to mill aluminum would be nice, but wood and...
    Thread by: woofguy, Sep 13, 2016, 1 replies, in forum: CNC Mills/Routers
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice