Separate names with a comma.
Some features disabled for guests. Register Today.
Any updates?
250 sounds pretty good especially with the gain in X. Thanks.
Did you eventually achieve a 300x500 cutting area?
Most low cost DC-DC SSRs are crap with an on resistance of 0.1 ohm (10% loss to heat) This one works well and isn't too much more expensive it's...
Glad I could contribute something to tempt someone else for a change. Not sure why the 20x40 slot would be different unless it was tweaked before...
That could be done. I essentially took the 20x40 vertex and made a 20x20 version of it without rails. And stacked the three objects together....
Looking good. I could send you the OpenSCAD file I hacked up. It might not be too hard to increase the size if the slot a bit in the source. I...
groups.google.com
Took all night and still has 13mm or so to go but the first tall bottom vertex being born. So it seems my OpenSCAD hacks actually worked at least...
I'm not sure how you would get in there to tighten down the stepper without the access holes. They are a bit undersized at 3mm so you may need to...
I just through them together quick. I'll look into why they are not manifold (they should be) probably has to do with stacking three together....
Just in case someone wants to do DiggerJ's double lowers, here it is as one part. I was messing around in OpenSCAD this afternoon and hacked...
If anyone is still looking for holes to make it easier to tighten the stepper motor mounting screws, it looks like you can simply go into the NEMA...
I would be interested in that. I have a Delta because I like the idea of a fixed build plate.
Right. The Azteeg X5 which runs Smoothie has DRV8825 drivers but only one extruder. The AZSMZ Mini from AliExpress runs Smoothie and accepts...
