Separate names with a comma.
Some features disabled for guests. Register Today.
Just to follow up, while I haven't tested the file on my machine yet, attached is the new "Openbuilds GRBL (mm) (*.GCODE)" file. Note that the...
Soooo, what I gather from above and then reading much of the internet today (LOL), is I have to modify the post processor file (OpenBuilds_mm.pp...
Just for clarity, in the screenshot attach, the top two post processors work, the bottom 4 don't work.
I know, I've been pulling my hair out with this problem for the past week. I kept eliminating one thing after another until the only thing left...
Opps! LOL. I edited and changed the file above. The post processor files ending in .gcode (grbl files, either from Vectic or Openbuild) does...
Didn't know I could check those settings while a job is running. Anyway, it's set to 700, down from whatever the defaults are (2500) Right now...
The 1/16 bit is just cleaning up the edges and adding a bit more definition. That feedrate is not what is set in the X32 controller (can't check...
Sorry, but not sure where to post this problem. Please move if needed. My setup is a self built CNC router machine that is controlled via...
Very cool. I've been an F1 fan since childhood. My dad was an F1 fan and I inherited the bug. First race I went to was around 1983 in Montreal....
THANKS! Just tested and it works perfectly. I almost re-oriented my cnc router, just so I could get my head around this. I'm not new to CNCing,...
Thanks, after I posted that, I thought, I bet only Y2 changes. :-)
So if I flash with the output, on the X32, the two "Y" ports will now become the "X" ports and the "X" port becomes the "Y" ? If so, time to bust...
I have a CNC router with a dual motor X axis. My controller is a BB X32 which only seems to support dual Y motors. How do I configure Openbuilds...
