Separate names with a comma.
Some features disabled for guests. Register Today.
I'm with you... but I'm also with him. Your 'implicitly synced' needs a lot of faith, when compared to a stepper driving a belt - and... by using...
This forum is incredibly painful to use unless you are on a PC. I've posted a lot on Google+ I try and stay off here unless I have a particular...
I'll build the next one before I sell this - probably JoesCNC or similar
After a delay for Christmas and to finish my Ox, I have started on the Routy build - but straight away I can see how the parts list/BOM doesn't...
Thanks. I always use a battery drill - learned that a long time ago :) And good thinking about taking the axis off the gantry - I should have...
It's complete... but I need to take it apart AGAIN!!!! The design is bad in one respect - you need to have all the bolts for the Z-axis adjusted...
Bell Everman don't own the patent to two belts sitting on top of each other - their system is completely different (and about $30,000). Don't...
This should do it: http://www.thingiverse.com/thing:16627
Were they the limit switches sold by openbuilds?
I can definitely recommend going to the dual-belt setup. My belts are only in finger-tight and they work great (same setup - Ox, TinyG)
I am not in a position to modify the 6mm steel gantry plates to accommodate adding additional bracing - perhaps you should take it up with the...
I just bought 40 sets of wheels so I'd be mad not to. I'll take the red ones, Anthony.
If 5mb/sec isn't enough, then maybe it's a problem. But, I don't have this problem with any of the more than 20 forums I frequent, nor do I have...
The time between the first post and the second is how long it took to reload and get back to the point you could re-enter another message. nearly...
And... after submitting, the site timed out and dumped me back to the main openbuilds.com home page. Normally I wouldn't bother, but it's so bad...
