Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Phoenix controller and Estlcam

Discussion in 'Control Software' started by Srednasoft, Aug 27, 2020.

Tags:
  1. Srednasoft

    Srednasoft New
    Builder

    Joined:
    Jul 24, 2017
    Messages:
    14
    Likes Received:
    2
    Hi,
    Has anyone used Estlcam 11.231 together with the controller card Phoenix by Hayri Uygur.
    The controller is based on Arduino Uno and runs GRBL 1.1f
    Estlecam will update the chip to its own firmware. Will that work on this card?

    5189BAC1-05FC-42D6-9C8F-16E6AA3B828D.jpeg C55DAC90-FE17-4816-BAA0-BC667DDD5CFD.png
     
    #1 Srednasoft, Aug 27, 2020
  2. Giarc

    Giarc OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jan 24, 2015
    Messages:
    3,016
    Likes Received:
    1,682
    It should work. In the setup in Estlcam choose GRBL 1.1.
     
    #2 Giarc, Aug 29, 2020
    Srednasoft likes this.
  3. Srednasoft

    Srednasoft New
    Builder

    Joined:
    Jul 24, 2017
    Messages:
    14
    Likes Received:
    2
    The problem is that Estlcam wants to write a new fw to the controller. Its own fw, that supports grbl 1.1. Will the Estlcam fw work on the controller?
     
    #3 Srednasoft, Aug 29, 2020
  4. Rob Taylor

    Rob Taylor Master
    Builder

    Joined:
    Dec 15, 2013
    Messages:
    1,470
    Likes Received:
    749
    Any "grbl controller" is just a repackaged Arduino Uno- this Phoenix, the BlackBox, all of them. They're hardware projects to make it easier and safer to interface the machine to the ATMega328p MCU IC.

    If it's grbl-compatible, it's almost certainly Estl-compatible.

    There are still inherent risks to reflashing firmware, though.
     
    #4 Rob Taylor, Aug 29, 2020
    Srednasoft likes this.
  5. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,051
    Likes Received:
    4,313
    You can avoid flashing, use it as a CAM only, export gcode and send the gcode using your normal workflow
     
    #5 Peter Van Der Walt, Aug 29, 2020
    Srednasoft likes this.
  6. Srednasoft

    Srednasoft New
    Builder

    Joined:
    Jul 24, 2017
    Messages:
    14
    Likes Received:
    2
    Ok, so it’s a risk, but it should most likely work ok
     
    #6 Srednasoft, Aug 29, 2020

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice