I upgrade my software yesterday. Ran a cnc job but had a minor spindle crash. Now the spindle wont run. I disconnected the 0-10v cables from my vfd and ran the vfd with a 10k pot. That seemed to run ok but was a quick on/off test. I checked the voltage output from the blackBox and get 0 volts. Every other aspect of the Blackbox seems fine. All steppers work. I'm not blaming any software issues but it was coincidental. Any new settings? Fuse is Ok. Would a crash ( only for a second) tend to damage the output of the Blackbox? Is there a way to reset it? I appreciate any guidance
