Welcome to Our Community

Some features disabled for guests. Register Today.

Newbie help please

Discussion in 'CNC Mills/Routers' started by Steve Clay, Feb 27, 2024.

  1. Steve Clay

    Builder

    Joined:
    Feb 21, 2024
    Messages:
    3
    Likes Received:
    0
    I have a Mostic 3018 machine I had it jogging with the supplied GBRL software (candle) I connected the openbuilds control software to the machine and sent the generic setup to the machine. Now nothing works. Can't jog, reverted back to candle and again nothing no control. What have I done and how do I fix it?
    Thanks
    Steve
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,051
    Likes Received:
    4,313
    If it was working fine, why would you load a custom machine profile to it? Grbl Settings are stored on your controller - that tool is for initial setup. Yours was already setup

    Restore your last good backup to go back to what you had. If you forgot to backup, that would be a second critical mistake, you'd have to ask the vendor what the original Grbl settings were then
     
  3. Steve Clay

    Builder

    Joined:
    Feb 21, 2024
    Messages:
    3
    Likes Received:
    0
    No backup. I'll contact the vendor.
     
  4. Giarc

    Giarc OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jan 24, 2015
    Messages:
    3,015
    Likes Received:
    1,680
  5. Steve Clay

    Builder

    Joined:
    Feb 21, 2024
    Messages:
    3
    Likes Received:
    0

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice