Welcome to Our Community

Some features disabled for guests. Register Today.

Torch slows and goes off

Discussion in 'Laser Cutters' started by Gus Mcfarland, Nov 10, 2024.

Thread Status:
Not open for further replies.
  1. Gus Mcfarland

    Builder

    Joined:
    Nov 9, 2023
    Messages:
    9
    Likes Received:
    2
    I biult an JDs garage CNC plasma table.I have it working and am trying to cut some dog shapes out of .125"
    some setting in Setup or Post or Possibly Tool setup.When i open in OpenBiulds The paths have Mostly blue lines with sections of red in curves.When the torch slows it goes off.
    I am useing Fusion and OpenBiulds Post.No ARCS[​IMG]
     
  2. Peter Van Der Walt

    Peter Van Der Walt OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Mar 1, 2017
    Messages:
    15,506
    Likes Received:
    4,422
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice