Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

Small Laser Engraver Concept

Discussion in 'Laser Cutters' started by Metalguru, Nov 20, 2016.

Small Laser Engraver Concept

Small Laser Engraver Concept

Discussion in 'Laser Cutters' started by Metalguru, Nov 20, 2016.

Low cost Laser Engraver build using all off-the-shelf components.

laser engraver low-cost off-the-shelf
  1. Metalguru

    Metalguru Veteran
    Builder

    Joined:
    Dec 29, 2015
    Messages:
    752
    Likes Received:
    548
    Metalguru published a new build:

    Read more about this build...
     
    #1 Metalguru, Nov 20, 2016
  2. Mark Carew

    Mark Carew OpenBuilds Team
    Staff Member Moderator Builder Resident Builder

    Joined:
    Jun 28, 2013
    Messages:
    2,758
    Likes Received:
    2,440
    Very cool @Metalguru this will make for a great laser! thanks for the share
     
    #2 Mark Carew, Nov 20, 2016
  3. Metalguru

    Metalguru Veteran
    Builder

    Joined:
    Dec 29, 2015
    Messages:
    752
    Likes Received:
    548
    Thanks Mark. Just a lazy Sunday afternoon brain exercise.

    MG
     
    #3 Metalguru, Nov 20, 2016
    Mark Carew likes this.
  4. HPB

    HPB Well-Known
    Builder

    Joined:
    Nov 28, 2015
    Messages:
    80
    Likes Received:
    52
    I'm all for simple designs using low cost off the shelf products! Looks like an all-metal design which would make this very reliable and the accuracy would be reproducible every time you use it.

    One thing I'd watch out for: The belt might grind against the slot extrusion when it winds around the wheels and loops around the pulley. Since the tooth side is facing towards the extrusion your belts will wear out faster and result in motion stops. I have a similar design where the extrusion is placed above the motor for this very reason.
     
    #4 HPB, Nov 24, 2016
  5. Anthony Bolgar

    Anthony Bolgar Journeyman
    Builder

    Joined:
    Jan 14, 2016
    Messages:
    354
    Likes Received:
    198
    For a laser diode, I reccomend getttig one from DTR Laser Shop, his prices and quality can't be beat.
     
    #5 Anthony Bolgar, Nov 24, 2016
  6. Metalguru

    Metalguru Veteran
    Builder

    Joined:
    Dec 29, 2015
    Messages:
    752
    Likes Received:
    548
    HPB, I am aware of the possibility. I did model this in Sketchup, and with the 30T sprocket and GT2 belt, it appears there will be adequate clearance to where the belt won't rub at all. Of course, I haven't actually built this to verify, but I intend to build one soon.

    http://www.openbuilds.com/members/anthony-bolgar.35746/, thanks for the tip. I'll have a look at their wares.

    MG
     
    #6 Metalguru, Nov 24, 2016

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice