Welcome to Our Community

Some features disabled for guests. Register Today.

Sign Up

CBeam OX

Discussion in 'CNC Mills/Routers' started by peter28, Dec 30, 2016.

CBeam OX

CBeam OX

Discussion in 'CNC Mills/Routers' started by peter28, Dec 30, 2016.

i wanted to use both the ox and the C beam C beam for the gantry because its stronger i also made the gantry 20 mm higher so i can cut thinker material i will maybe later go to rack& pinion on the 1500 mm Y axes also instead of the V wheels i will maybe go to hiwin in the furture

OX body with the Cbeam gantry
  1. peter28

    peter28 New
    Builder

    Joined:
    Sep 9, 2016
    Messages:
    22
    Likes Received:
    4
    peter28 published a new build:

    Read more about this build...
     
    #1 peter28, Dec 30, 2016
    corpore likes this.
  2. peter28

    peter28 New
    Builder

    Joined:
    Sep 9, 2016
    Messages:
    22
    Likes Received:
    4
    ] i am going to make a OX body with a C beam gantry
    the OX plates will be a little bit different ,the gantry will be 20 mm higher:)
    also i don't know if i can use the high torque nema 23 motors directly on the 4 axxes or do i need to use the standard nema 23 motors?o_O
    in the furture i maybe will go for a rack& pinion build with HIWIN liniare rails.
    side.jpg
    side.jpg side 2.jpg side 3.jpg side 4.jpg
     
    #2 peter28, Dec 30, 2016
    Last edited: Dec 30, 2016
    Mark Carew likes this.
  3. peter28

    peter28 New
    Builder

    Joined:
    Sep 9, 2016
    Messages:
    22
    Likes Received:
    4
    Just a question Can i use the nema 23 high torque motors directly on the C beam and Y and Z axes? or not
     
    #3 peter28, Jan 2, 2017
  4. Darathy

    Darathy New
    Builder

    Joined:
    Jul 12, 2016
    Messages:
    74
    Likes Received:
    21
    Dont think you can ,diameter of the Coupler between the motor and the leadscrew is 20mm which is the same as the depth of the C section ,it will bind . Use 40mm spacers Aluminum Spacers On the Platemaker i have 2 on each axis.
     
    #4 Darathy, Jan 2, 2017
  5. peter28

    peter28 New
    Builder

    Joined:
    Sep 9, 2016
    Messages:
    22
    Likes Received:
    4
    so i can use the high torque motors directly on the motors but i have to use the 40 mm spacers ?
    i do not need to use the belt reduction then?
     
    #5 peter28, Jan 2, 2017
  6. Darathy

    Darathy New
    Builder

    Joined:
    Jul 12, 2016
    Messages:
    74
    Likes Received:
    21
    no ,you dont ,you can put them direct to the leadscrews.
     
    #6 Darathy, Jan 2, 2017

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice