This is a simple holder for your xyz probe. I printed this standing up, I did use supports but that is probably not necessary. There are two recessed mounting screw holes (20mm on center) that should work for low profile m5 screws or drywall screws. The threaded M5 screw hole in the face is for a low profile screw, this gives you a place to stick the magnet.
- 3D Material Used:
- PLA
- How Long Did It Take?:
- 3 Hours for good quality
Here is a link to the fusion file Probe Holder
XYZ Probe Plus Holder 2021-02-16
Simple 3D printed holder for your probe!
-
JCPhlux, ron cochran, Bernard Gauweiler and 9 others like this.
