Intermediate Apple Everything Holder

Software:

Fusion 360 and Openbuilds control

Machine Time:

~22 min

Bit or Laser Size:

1/4 Round End Mill Wood/Acrylic/Plastic Dial 3.5 DOC ~ 1.5

Feeds & Speeds:

19000 rpm or a 3.5 on the Dewalt router. Feeds were about 1250 mm/min

Materials:

Piece of black walnut we cut down in my neighbors yard.

Pretty straight forward build, the hard part was being accurate and getting things right the first time. (only had one block of wood) spent about 4 hours the first night drafting the model in Fusion, then the next night after scrapping most of that work I spent another few hours programming the CAM on the model. I wanted to keep it very simple on the top which meant cutting some apple wires in half, so I could slide the wire right though the block, that ended up being a good decision in the end. Please give the video a watch and maybe visit my instagram @jakeslabnc