Separate names with a comma.
Some features disabled for guests. Register Today.
one ting I would like to ask the guys using belt, on big cnc, is the belts ok. I tried 4 different tapes to stick bottom belt but it would always...
hi rick, just been trying out, lower speed, most I can go on velocity is 700, motor sounds ruff any more, my main problem is when I try circle its...
hi rick some info, Trapezoidal Spindle - Part Number TR12x3D x1500mm long (Ø12mm x 3mm pitch)(x1 revolution = 3mm or 0.1181") DIY CNC Kit 5...
Hi guys after having trouble with belts pulling out slipping, changed to lead screw, but having some trouble with these, the screw is lot slower...
Hi Donald Thanks for the advice, yes hope the 8mm phenolic will hold as I've added 50mm in hight to the plates, the er20 collet is the one I...
kev20009 published a new build: This Build Is Is Inspired By OOZ Nest CNC, But With Some Changes, Read more about this build...
Hi guys I'm building cnc from ooz nest, but added a lot of new features, the one thing I want to fit is a 2.2kw spindle, as anyone run these ok...
Thanks mark, kev
Hi guys what software opens Skp files, I've tried vcarve pro, Any help appreciated Kev
thanks ryan I have the acme colot for nema 23 please, thanks kev
thanks for reply ryan would you use all 23s or a 17 on z axes, if yes to 17 could you swap that coupling, thanks for this ryan, kev
hi ryan did you get my email about acme rod, and z plate, got the order done last night for you, thanks kev p.s can you check the couple joint...
Thanks Ryan. Kev
Well I got some motors last week and there was nearly 2mtrs of wire on them, But if your short you could put a conector on side of stepper, Kev
That's Ryan, So they are cut inside then, can screw them in just tight for hand, but was thinking could tap them that would make doing the...
Thanks will try that, As that could be it, still learning the software, Thanks kev
Sorry Ryan Should Have Said The z axes From Bit To Spoil Board, As Im Doing The 1200 Was Woudering If The Hight Would Be Enough, Thanks Again Kev
Hi Ryan Starting Cutting Your Plates Today, But The Plates Missing Is The Motor Mounts, They Are Stp Files, Any Chance You Would Have Them In...
Hi guys Can't seem to find the z axes hight, as I will be doing 1200 x 600 cutting area, and was wondering if I need to extend the hight a bit,...