Separate names with a comma.
Some features disabled for guests. Register Today.
I've had good luck with 2-flute 3/32" end mills for making 3mm holes in aluminum. I also use helical ramp in F360 making these holes as pocket...
Seems like aluminum v-wheels would be more readily accessible: Aluminum Dual V Wheel Kit For 3d Printer
John, Thanks for reporting back! I hope your vendor did the right thing... I got the same Fault indications (on all three Bigfoots) when I was...
Executable is in the download: GrblPanel-Release-1.0.9.17.zip Unzip it and the executable is GrblPanel.exe
The driver is probably fine. Your VRef may be set too high. To set VRef appropriately, follow the guide here: Bigfoot BSD109A : Panucatt Devices...
I would first check with a fixed square, instead of an adjustable square. (Many adjustables are not accurate enough.) And yes, I would correct...
GRBL doesn't support M6 tool change command. You will probably need to edit the Estlcam gcode to replace lines containing M6 with some custom code.
I've got the M1 Pro, and while I haven't reprogrammed it with Estlcam, it shouldn't hurt it. I've reprogrammed mine with GRBL 1.1 (from 0.9),...
Thanks, but it wasn't my idea. I wanted to do it to help plumb my mill. It makes it easy to tell, by dragging a fingernail across the surface...
Keith, I haven't used the Strooom post-processor yet - I was just pointing out about the link. (I do plan on using it once my machine is back up...
Kieth, I also noticed in your cut file you have an M6 command (which throws an error in grbl). I don't think you are using the post-processor...
Once again, my suggestion doesn't have anything to do with lubricant. But Gary Caruso's post above I think hits the nail on the head. Too many...
I guess I forgot that I said "I will report back", sorry. I ended up using 9000rpm at 3500mm/min. I used a 95% step-over (24.13mm), and 2 passes...
I'm having trouble finding/believing the .8 and 1.5 are similar weights. The .8 is 65mm diameter where the 1.5 is 80mm diameter. The 80mm would...
I've been looking at these lately as well. I currently use a Makita RT0701C rated at 1.25 HP. It's a bit noisy, but it works OK and has...
I'm not 100% sure why, but I suspect it has something to do with being the least "abrasive" for the delrin nut-block. They also recommend the...
OpenBuilds recommends silicone lubricant. This is what I use: Shop Blaster 11-oz Silicone Lube at Lowes.com
The plate in the drawing is 216 x 390. (Be sure your units are set to millimeters.)
Found this online. Sounds like he is wiring his setup to do what you want. I haven't watched the entire video, but it might be worth a watch....
Should be able to use the same control board. Not sure about implementing a switch since you have a spindle with a VFD. From what I've read,...
