Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks Mark - couldn't do it without you guys! Steven, sure thing! .step and .sldasm (solidworks) models are now loaded in the file section....
I haven't gotten that part of the post up yet, but we broke all the signals out to screw terminals so no crimping or soldering. Also have a Motor...
arcrunner: Much beefer, much easier to setup and get going too! Rob: GRBL is running a bang-bang acceleration management style while looking...
Michael published a new build: Coming soon - stay tuned! Read more about this build...
Hi Khalid, you should be ok with the current setup - we run the same all the time. A few things though - 1) if you dont need the motors locked...
Hi guys, Sorry this post was just brought to my attention - the LEDs by the motor drives simply indicate voltage going from the motor driver to...
Hi, start here under the C-beam section: 5. Troubleshooting · Spark-Concepts/xPRO Wiki · GitHub This will get you close, most of the steps...
@CharlieShimota: Yep thats the one - there are a few different flavors out there that you should look for (or look out for). The cheaper clones...
Hi planga - I'm tracking now, I thought the issue was only when loading with 1.1 (apologies for the slow uptake on that one...). Don't buy a new...
Very nice build Jim! @Kyle Barrett: Glad to hear things are sorted, please reach out if you need anything else! We are getting our installs...
@planga, sorry I missed see that this post was updated. I have looked aver everything and there shouldn't be any reason the V2's cannot be ran...
Hi folks, gonna jump in here with some questions and hopefully some help :) @Aaron D: On the voltage output from the spindle speed control -...
Can you upload your gcode file as well? How did you make the file?
Hi Planga, Nothing looks terribly out of place with the settings ($26 should be around 250 for when you put limit switches on, and you may try...
Hi Planga, Congrats on finishing the build! Sorry to hear there is trouble abound... So the first issue sounds like the X and Y steps per mm...
Hi Folks, I wanted to throw up a quick note as I have received a few emails today about some misbehaving V3 boards. On the new V3's (gloss...
Olecam, There is a 5V regulator on board. The irregular voltages on the 5/3.3V rails are typically due to input power noise or motor feedback....
Hi NickD, On the V2s, there is a reverse protection diode on the output of the 3.3V LDO so no change is needed. You can set the...
Hi George, Sorry I didn't see this message come through. It sounds like there is a short pulling the Y dir pin to ground. If you pm me...
Nice looking build! The C-beams are a lot of fun to build. Quick word of warning - it looks like your xPRO is on top of your power supply. If...
