Separate names with a comma.
Some features disabled for guests. Register Today.
Just connect the two Y axis stepper driver inputs in parallel, ie: Step Y1 > Step Y2 > Arduino D3 Dir Y1 > Dir Y2 > Arduino D6 Also need to...
About 2.75 square meters! :jawdrop: MG
Hi John: I don't have a parts list for the upgrade, but it's all mentioned in the build description. MG
You might be able to. There might be a way to reload the EEPROM using a GRBL $ command, but I'm not that familiar with all the $ commands. I...
This is from the GRBL Wiki: "After flashing, Grbl tries to check the settings in EEPROM. If it finds an incompatibility, it will automatically...
Loading the GRBL firmware on an Arduino 328 automatically erases the EEPROM so it doesn't cause problems if setup parameters are added in the...
Yeah, exactly. I use a 5A automotive blade type inline fuse between each driver and the power supply positive lead. Just for safety to prevent a...
Easy answer - make it shorter. Hard answer - there's been a ton of speculation about ways to increase the stiffness. Everything from filling...
It wasn't because you were trying to point out a bug that you were banned, it was because of your ****** attitude. Which you have so amply...
Can't beat free... MG
Yeah, I think those are a bit overkill for the Z axis. The MGN9mm rails fit actually just inside the v-slot, right at the top, so they should...
Kewl. I'm working on a design that uses all HiWin style square linear rails. Parts on order. Uses 9mm rails for the Z axis, 12mm rails for the...
Steal away, Gary. I stole it from OB CBXL plates anyway. No honor among thieves, right? Hey that kinda looks like my Ox HD design. But I see...
I stand corrected. Thanks Ryan. MG
Don't think so - Limit Z should be pin 12 from V0.9 to V1.1... I find you usually need .1uF caps across each limit input to ground, and sometimes...
Hmmm... Not heard of that one before. I know the GRBL Settings changed from V 0.9 to V1.1, they added the laser stuff. That's why they force...
I think it depends where you get your kit. Some have it, some don't. Perhaps it's been a general upgrade. I thought just my kit supplier was...
When you update GRBL firmware, it wipes your configuration memory. You have to go back in and reload all the settings you had before. I hope you...
Cool. Glad I could help. MG
I pretty much always use an Arduino Nano with a screw terminal shield to make wiring easy. It runs GRBL. I Never use XPro's, I have a very low...
