Separate names with a comma.
Some features disabled for guests. Register Today.
Hey Justin: The outside of the spoil board is attached to the 20x80's with screws through the board into tee nuts installed on the top outside...
Metalguru published a new build: Improvements both real and suggested for the Workbee assembly Read more about this build...
Hmmm..., I kind of like the Gradus M1 pro, it's 4 times the board that the Xpro is, and it has replaceable drivers. With the Bigfoot drivers,...
https://openbuilds.com/members/darkpenguin.88250/: If you set $1 to 255, (Read the GRBL Wiki on this setting) you need to have the enable inputs...
Sonny, to change to a happier (hopefully) topic, how goes the battle with GRBL for the Leonardo or other higher power Arduinos? I started hearing...
Hi Dave In the GRBL settings, you have to enable Hard Limits, $21=1. You may also have to use the Invert Limits $5 if your switches are...
I recommend using a good power filter to plug your computer and machine into, and plugging the router/spindle into a completely different circuit...
Come on, Jacob, you don't know how to use Google? Ten seconds on Google brought up the photo below. (Although I prefer to use a +5 based wiring...
Funny, I've been using the Chinese Nano's with the CH340 for a while now and have not had any reported issues. I did have one guy that said his...
Sure. Just building a new machine, so I'll do some photos over the next couple of days. MG
Doesn't need to be shielded. But you can use shielded wire if you want. Just keeps radiated noise to a minimum. Make sure to only ground the...
Whatever floats your boat. I find that stuff with Prime shipping is always a bit more money than non prime, so the difference in costs are...
Yeah, the Nano shown should work ok. Be aware that those kits come unassembled and you have to solder everything to the board. PSU might be OK,...
I prefer the Arduino Nano and it's screw terminal shield, its a lot easier to work with than an Arduino UNO. 1/4 the size as well. The stepper...
NEVER connect DC ground from your Arduino to the chassis or motor power supply grounds! The arduino is isolated from the motor supply by...
I would definitely NOT recommend the Xpro. Anyone who's seen my posts knows I have an extreme prejudice against that particular piece of...
Not really. You need a controller (arduino), stepper drivers DQ542 or equivalent, and a power supply. Everything except the Arduino is available...
I don't think it will accept an illegal value. For instance, with steps/mm, and all of the other decimal values, it will only accept up to...
No need to shout! I don't think there is a version that will run on a Leonardo. There was some discussion on it on Github a few years ago, but...
Nano (one of hundreds):...
