Separate names with a comma.
Some features disabled for guests. Register Today.
Ah I was misreading the spec sheet for the regulator I was looking at, seeing the minimum voltage and thinking it would also boost the voltage....
Assuming what I'm thinking about is true, lead me to think about the following. What I'm wondering is if I could split off the 0-10V signal and...
Is the signal that is ,sent over the relay er, driving the relay rather, the same signal that is sent to the 0-10V pins? If so I'm guessing we...
Perfect I can now see everything turn on with M3S24000, but oddly if I try to change the speed to below 10-13k RPM it just shuts off. I have the...
I'm going through the BlackBox documentation and playing with the various features and I'm a bit confused about the internal relay. I see we have...
This might be a reach, but is the current level set too low for that axis driver, it might be worth checking the setting for the Z axis...
I get it :) but as frustrating as it is on one hand I do feel like I’m learning things going through the process. I don’t plan to give up before...
I've reached out to Jacob from the other thread but have not heard back. Re-read the thread you linked and modified PD073 to be 0 instead of 120...
Good thoughts, thanks Peter, I will reach out to them.
I've gone back and tried values for PD010 as high as 50 and still no luck. I'm looking at going the relay route but thinking through that more...
Also as an aside, I had to replace the USB cable that came with my black box as I was getting USB disconnects every time the VFD would turn on. I...
I've tried values as low as 4 and as high as 10.5 but no change in behavior. I'm not certain this is making any difference. I may go the relay...
I'm not sure what value to use for PD010, the default was 8.0
I had seen a setting for switching from FOR to REV in the VFD settings, but in that case it's looking for a run command on one of the pins and...
After reading the VFD manual over and over again, plus the time playing with the different input pins, I've come to the conclusion that if I want...
Thanks Peter, I had thought that might be the case, but I didn't think I was seeing the voltage on the pin change. I'm going to go back and retest.
Is there a way to control the DIR pin on the tool head connector in grbl?
I found my issue. I needed to have PD008 set to 110/120 instead of 220, it's working now.
For what it's worth I'm getting an ELu.A error code on the VFD, which means it's got low voltage, but I'm getting proper voltage at the outlet so...
I've got a problem with my Spindle, 800W Air cooled, using a 1.5kw VFD. I've got through all of the settings but when I try to run it it won't...
