Separate names with a comma.
Some features disabled for guests. Register Today.
Would probably need to go with servo motors for that speed, with any hope of precision. Gary
Pine is very bad in this regard, maple or poplar will be much better, also if just going to paint MDF works great. In the pic it looks like you...
For the 4x issue was it the depth of cut vs total depth? taking 4 light passes, this is normal if this was the setting. I don't think I've ever...
Hi David, Looks like intermittent direction changes, one of the four motors wires connection is loose Gary
Sometimes the brushes for the dust shoe are causing significant lift when the machine changes direction. Gary
Contact the parts store and let them know the issue, if they are just a bit tight you can use a drill and cycle a bunch back and forth to loosen...
Use 1600 microstep, this is most common, or 3200 at the most, they should all be set the same for ease of tuning. So now you have both motors...
Check the 120-220ac switch on the side of the power supply Cheers Gary
Without the 0.5mm spacer the dual belt will be loose, this might be part of your issue. Many people use a double sided tape with the required...
Maybe tighter still use a clamp or a lever, calibrating across a large distance and accept this will never be a pro milling machine will help....
Mine is better than that Yes, more tension will help, pull the motor up firmly while tightening the bolts.
My new x plates are like your v3 (or more like v2) with the motor on the diagonal and using three bolts, so you can get the pulley closer, and...
Are you saying no matter what way you command it only moves one way? is the movement smooth or erratic? Most likely the dir signal wire is broken...
Longer runs with belts means more stretch and the belts are a bit springy. Depending on the use case it may or may not matter. There is also...
Sounds like you don't have a good starting point for your steps per mm, need to figure that out first and go to cal from there. post your settings...
Another thing to watch out for is loose parts, need to use tabs (bridges or whatever we call them) to hold the loose parts from moving and...
Upload example files so we can take a look. regards Gary
The router is turned on and off by the gcode, yes you select the speed manually turning the knob before starting the project, the feed rate is...
You have the router11? Many people use the IOT switching power strip to allow on off control, for RPM set ahead of time, appropriate for the...
I'm a bit confused as to why you are giving up on this last issue? Need to select a machine type to tailor the code for the machine, this will...
