Separate names with a comma.
Some features disabled for guests. Register Today.
Ok that helps, so you should see from the controller board Y-Pulse and Y-Direction signal wire running to both Y drives, in parallel, trace those...
There are so many youtube videos on H100.. as you said its hard to find the right one. That's a huge cutter, is it carbide insert type? Is it...
Could be from chatter, or not using a sharp bit, I recommend a down-cut bit on plywood Gary
mach 3 is software, what model drivers/hardware are you using? a pic could be helpful as well. Thanks Gary
I just looked at my inexpensive er11a nuts I found on amazon and they don't look like that one in your pic, and I've had no issues with them. I...
Do you have the collet fully snapped into the nut?
So your lead screw is so tight on the backlash nut it can only be turned by a wrench? lead screw and anti-backlash nut should turn smoothly and...
Most common reason for this -mechanical binding, with the motor disconnected can the screw be turned by hand easily (same on both sides) -bad wire...
Thanks, thought that looked weird, so the relay spec is missing from the docs? [ATTACH] Gary
Up to 24v 5A Switched Output for Coolant or LED devices from the spec list Cheers Gary
Don't run the stock cable through the chain with the other cables. Too much EMI Cheers Gary
Hi Charles, Not sure I understand your question? can you link the listing or screenshot? The backbox comes with a connector, you need more? Relay...
For flexibility in setup, can be operated in pull up + or down - for control.. for example by default Arduinos digital control "pull to ground" so...
Using the GRBL post processor? Gary
This is the design I'm still using.. fixed z is the way! Cheers Gary
There will always be the issue when the shoe is off the edge and lets chips fly in that direction (I think that is what you are talking about?)....
While I agree in theory, mine has worked flawlessly for years now, as has many others. Use at your own risk however, some of the cheap ones are...
Also check the collars that constrain the lead screws
Hi John, could be a chipped endmill, or aluminum welded on to it (can be scrapped off usually)? which spindle are you using? is it one of those dc...
Could it be your brush vac brushes smashing down on the work surface causing too much drag? IMO best dust boot is fixed z height so you set it to...
