Separate names with a comma.
Some features disabled for guests. Register Today.
Did you try increasing your current as well? Gary
Lucky that steel has excellent creep resistance.. our plastic wheels on the other hand will get a flat spot. Don't get me started on back emf! Cheers
Are you using a BlackBox? the current is set with the drivers not the software, on the Blackbox there are current adjust pots. When you say...
Hi David, post your file you are using to get the circles, the drawing and the code if you can. The current pots should be ~75% toward full if...
Depends on many factors, like your vacuum, the boot setup, the material. If you are cutting close to the material edge and there is a big leak...
Which post processor are you using?
Hello Dr. Did you remember to home and set your work zero? have to do that every time. It still jogs in the correct directions I assume? Gary
Looks solid! 3d printed blower?
The Granit was one I can think of, very stout. Maybe not exactly what you are describing though. cheers Gary
Check out the builds area, there are many examples. Cheers Gary
Did you reinstall the drivers? docs:blackbox:install-drivers [OpenBuilds Documentation]
I think you will want to be able to V carve your text, look up the difference between 2D text and V carving. The way I do it is SVG files from...
I've been using stepper cable like this one for 4 years with no issues. for the probe I replaced my lead with a 20awg silicone high strand very...
This will limit you to parallel/square cuts (nothing tapered), This is ok for your products? That table design looks great! Gary
The SVG is only 2kb and has no content and the pic is difficult to tell what it is. I think you want a round over not a chamfer or "bevel" Cheers...
Ground for sure and use shielded wire as well (and connect the shield to ground at one end). Make sure everything is earth grounded, the cnc...
sometimes it's easier to post process using a router table or even your cnc router with a v-bit and a guide bearing to make a chamfer.. using your...
Can use the Estlcam flash on BB.. works great, easy to revert back to GRBL if you want takes seconds, estlcam saves your old flash before...
Yes, the nut block should thread on smoothly with very little friction. Some people have success using a drill, chuck the rod and spin it through...
Very much looks like a bad connection OR you just need to turn the current up a bit on your drivers. should be about 1/2 way on the pots from...
