Separate names with a comma.
Some features disabled for guests. Register Today.
Fiber OX update Going together nice :) [ATTACH]
One other thing I can think of would be the endmill is to far out side the chuck. Only the cutting surface and 1/6 " of the shank should stick out...
The RPM is way to high you want about 10,000 rpm Next the alexi bits not right for the job and the inventambles are for acrylic The last bit on...
A note when using high helix bits, be sure to secure your work well. If the bit hits a soft spot or chips it can pull up with a lot of force
I have a local supply KBC tool that I go to. Little costly but bits last a lot longer I also have a new type I'm about to try on the next few sets...
Bits snapping is not a good thing at all. First thing is the end mills from eBay have never really worked for me and snap fast Next how fast is...
I was stupid lol
Yes it can be done, go slow, use sharp bit and only half way. Don't hold it with your hand as it will pinch your fingers when the flex pulls...
Ty :) It is a ceramic fiber board used in electrical switch gear to isolate buss bar and phases Extremely strong :thumbsup:
The 1 mm goes inside the wheel between the bearings and 1/4 spacer is used outside
Well the fiber OX parts are coming out how I was hoping, so that's a good thing :) It's a lot of work but the end results should be worth it. Here...
I'm super busy but I will send you a PM
This is something I'm working on... A little surprise, few pics now and then for OX porn and yes it is also for testing different options to...
Yes a complete OX will be milled with the fiber board and tested. It will be a small footprint 700x700 :)
It connects to the rear 20x40 and a 90 black bracket, 2 x 8mm M5, 1 x nut and 1x tee nut On the X side 70 mm M5, 1x 1/4 spacer and nut to lock...
I better order some 30 mm now along with 3 x GT3 pulleys/ belt so it's here for the fiber OX :)
Test fit went well :D [ATTACH] No movement with eccentrics not tensioned. This fiber board is just as stiff as aluminum but a lot lighter...
To fix this issue simply drill your spacer block mounting holes in the x plate a tad bigger. Then tighten the spacer block while pushing inward....
BAM ! Some fiber in yo face lol :ROFL: [ATTACH] SG-50 is a non-asbestos ceramic refractory reinforced with continuous fibers to increase the...
I got four you can have just pm me your address and I will send them your way
