Separate names with a comma.
Some features disabled for guests. Register Today.
mount it to the aluminum extrusion instead of getting a heat sink. Adam Cooks linked us to a conversation on low quality SSRs buring up. If you...
Haven't heard anything back from OpenBuilds. I'll take a look at options this weekend. Would be a shame not to hit 100 pages though ;)
Might be refering to these: 10 Pairs 100mm JST Connector Plug Cable Line Male+Female for RC BEC Lipo Battery I use them on some of my quadcopter...
If you rotated it 90 degrees would you get the 10mm back?
Hmm, 3D print a double ended wrench so you can tension both at the same time? Else two wrenchs, hex key, and nut driver all at once! 4 handed...
Let's wait for an update from the OpenBuilds team before deciding anything. If nothing is in the works, then yes I'd agree. Forums should allow...
I'll check in with the open builds team to see where they are at in making any changes. If nothing is on the horizon it shall be so. @Mark Carew...
Ronald, Nice enhancements. A few questions: 1) what size spacers are you using with the mini v wheels in the top portion of the plate sandwich?...
Are you using two mini V wheels per side? If so, what size spacer are you using between them?
You could also design and print a toothed sleeve to fit between the two flanged bearings. Or even a design that uses normal M3 bearings.
I don't see an issue with twisting it, especially over the length of your bed size. If I knew these existed (below) I could of incorporated these....
What do you set your retraction speed too?
5mm (will depend on actual tube length and filament used though). I've gone up to 8mm in my setup but had occasional issue where it would jam on...
Nice, looking forward to the pics. Did you have any issues with printing the V-slot "groove" on the underside of the vertical slot?
Yeah, they do look pretty cool. I'll take another look at them later today as my last reply was a bit rushed as I headed out to work... you made...
The reason I designed my extruder with a spring loaded idler arm is to prevent the ovaling you are describing. If the filament is becoming oval...
Yes that would be easier for me! If you didn't I would want to add it to the permanent files so it doesn't get lost in the forum.
Nice, solves the lack of a third hand issue. :)
Man, now I want an X carve or C-beam. Hopefully I win the $99 free shipping! Nicely done.
Here is my first build. It is a H gantry 3D printer that eventually led to the development of the CoreXY 3D printer published as the C-Bot. [ATTACH]
