Separate names with a comma.
Some features disabled for guests. Register Today.
The other two are for round brass nut options. I think this is the one you want.
Pretty good start, have any more pics of the hotend carriage? I am curious about what you've setup here.
Definitely not, just the cost of a few T-nuts and bolts.
Nice, tbh I designed the rework parts assuming that the front/back or offset leadscrew option would be used and never check that clearance. What...
Yes that should be good, but keep in mind that from that dimension I have a +/-1mm slot for tension adjustment.
Please do, you never know! Would be a shame not to share them after doing all that work. If you post them as a remix to the C-bot on thingiverse...
All, @trublu832 (aka spauda01) has completed his D-bot variant (offset Z steppers) build guide. This is a TON of work and he has done an...
@Chris Roadfeldt Making some VR googles? [MEDIA]
Cool, do you have a pic? You might be causing it to bind with the horizontal Z bars. Loosen them off, level them to each other, run them up and...
You have to consider another 5mm for the mount thickness that the motor connects to. So from the bottom of the horizontal 2040 extrusion one...
Does this cover what you need? The stepper shaft center is the vertical line in the box. Do you need a shot from the side perspective? Some of...
Not that I have seen, but I would love to see you give it a go.
Unfortunately I missed it, cool though.
Basically the red and black go to the ramps board and provide the on/off signal to the relay in bang bang mode. The other pads are meant to...
First part: Sure, will do, may take me a day to two to get around to though. Second part: Accessibility to your print bed for maintenance and...
The small arms mount tot he rear plate, extending down and in each direction. The fans attach with their arms that allow you to pivot the fans to...
If I were to use an aluminum plate as a base for the heated bed, then I wouldn't need the Z cross rails at all for the setup! Hmm 4040 or C-Beam...
I've designed one, but it needs some reinforcement as it is vibrates too much for my liking. Cooling is good though.
Yeah, I think it is due to the heavy moving mass. You'll have to clamp down a lot on you acceleration limit to get the vibrations out. That...
Just an alternate idea if you don't like front & back plate mount option. But yes, the nozzle would be offset in the same direction of the XY bar.
