Separate names with a comma.
Some features disabled for guests. Register Today.
Very nicely done!
I did nothing to the jumpers. There is nothing that I could see in the instructions I linked that mentions doing anything to the jumper. The 1...
You should be able to use the two. You need PWM and Ground and they are conveniently right next to each other. Just be ABSOLUTELY sure you put...
Here is how you connect the IOT to the blackbox. docs:blackbox:connect-dewalt-iotrelay [OpenBuilds Documentation] Technically, you should be able...
Vcarve makes importing and carving 3D files super easy. I do a lot of 2 sided 3D carves and rotary 3D carves. It only takes a few minutes...
Is there any chance you have a loose wire on that motor that is making the grinding noise?
You say ignore the Y and Z, so you are only using the X. The problem you may be having is that the machine is waiting for the Z to home first...
It sounds like maybe too high of acceleration. The X is used at high speeds going back and forth for rastering which may be why it shows up using...
More info is needed like a sketch since I have no idea what you need.
What do you need. Are they simple plates that you need a .dxf file made?
Do you have a picture of what happened? Is there anything mechanically loose on the machine. Are any shaft couplers slipping. Are you trying to...
You should be able to replace the controller with a Blackbox. Here is the documentation for hooking things up. docs:blackbox:start [OpenBuilds...
It could work, but since it does not come to a fine point, you would need to offset your beveling pass by the diameter of that center part of the bit.
I only saw one hole on that svg. no perimeter. For cutting out the profile and holes you need a cutter like this, or smaller if the hole is...
That is how I do it, unless the slot or opening is too small.
It would be difficult to put a smooth bevel on the edge with out using a chamfering or vbit to cut the bevel after the parts have been cut....
It looks like you put your eccentric nuts on top on the X axis gantry plates. If that is the case, that may be your problem. If one is tighter...
If you are using OpenBuilds Control, you change the $21 value to $21=1 in the GRBL Settings. Grbl v1.1 Configuration ยท gnea/grbl Wiki
That is awesome that they are finally for sale separate from the RoutER11!
There are no simple free solutions that I have found for carving 3D files on a rotary which is why I went with Vcarve Desktop which makes it real...
