Separate names with a comma.
Some features disabled for guests. Register Today.
the lead screw will travel 8mm per turn (so the lead is 8mm) 16x200=3200 steps per turn, you will have 3200/8 = 400 steps per mm, so $102=400...
hi Tassie, you have to calibrate our steps per mm and make sure everything is going the correct way first. what size pulleys and what micro step...
Dual belting works very well too.
maybe 174.3... No seriously it all depends on what you are cutting and with what bit and the RPM.. that's a rather fast cut speed (feed rate),...
What's nice about both of those programs is the huge user database of parts already available so you can find the 80/20 you want in the library...
what linear bearings are you using.. I see MGN12, from where, how do you like them? Thanks
with GRBL you really only have X, Y, Z.. so you just pair up any signals you want you can chain together multiple drivers on any axis no problem.
Chrisclub1 makes sweet four post C-beam ends.. not cheap but quality on ebay
Most people are using fast decay for the solder jumpers on the back of the board. If is was mine i would use a small jumper wire first on X or Y...
Ok, only thing that still looks strange is the $0 is 3 instead of 10 which is default I thought? Using an xPro V3 right? You did the fast decay...
what happens when you use the 500mm/min feed rate? sometimes slow feeds act weird with grbl. Jogging can do strange things as well.
yes, I run my ox at 700 for x and y and 600 for z, but i have bigger motors and dq542ma's so it will be different.
try turning your acceleration up, should be able to run around 500 to 600, you are accelerating and decelerating for each line segment, never...
You can replace the makita cable very easily take the top cover off and there are screw terminals, replace the cable with shielded 2 conductor of...
Hey Foggin, what's your microstep and decay set to? list your $$ settings for us. are your wheels super tight? might be too tight Cheers
yeah the 8mm side is a loose fit on the openbuild screw, I used a couple layers of aluminum foil duct tape to take up some of the gap. Clamp screw...
That kind of difference of calculated vs calibrated is typical and fine. I've been wanting to try the Estlcam sender myself because i want to try...
and the set screw... maybe they just sent the wrong one?
yes that's a big one for sure, it's very easy to replace your router cable with a shielded pair cable, run the drain to the star ground, for the...
