Separate names with a comma.
Some features disabled for guests. Register Today.
From my (brief) sojourn into researching a possible 3D printer build, it seemed that Klipper was the best firmware out there. I don't remember the...
Two-hole conduit clamps or pipe strapping with long enough bolts to not bottom out and get a really good torque on it. Rear supported by poplar...
I'm still Team Loose Wire as well, honestly- I dealt with it recently when putting the laser together and it really does cause some weird...
Look into high speed machining (HSM) and its use in maximizing utility of lower-rigidity machines. This is increasingly used in industry (as floor...
For testing purposes I'd probably just write a similar program to bounce it up and down at various speeds that I could run on repeat. Since the...
If you're not procrastinating by posting updates on OpenBuilds, are you, in fact, accomplishing anything at all?
It's fixed now, for anyone trying to use it!
Rotating-nut builds are semi-common in long-travel screw-based machines where rack and pinion isn't an option for whatever reason- accuracy,...
Back in 2016 the primary objective of this build was to produce the cheapest possible laser etcher for someone with moderate production...
Still showing as step="1" for me on the cut and pass depths after refreshing a couple of times and trying in a private window. (And step="0.001"...
Oh, spoke too soon: [ATTACH] You're gonna have to update this guy too, hahah: [ATTACH]
I see it. Yep, that did it. If people are defining their tools more precisely than that, they have bigger problems! :ROFL:
There's apparently a simple fix I just tried, but I'll go back in and refresh to see your update. [ATTACH]
This is a (problematic-slash-incomplete, now I actually look at it, but I wasn't planning on using it anyway) DXF from Eagle, and I still get an...
First thing that pops into my head: Cast a concrete block, say 18Wx12Dx10H (or whatever's appropriate, that general aspect ratio though) with...
I haven't yet added my switches into my config, so I'm not sure how helpful I can be just yet in practical terms, so that notwithstanding... The...
While you're in there, double-check that your acceleration is set to a reasonable range- somewhere between 10 and 150mm/s^2- for testing purposes,...
By my understanding, grbl will define machine home such that the entire work area is in negative space and machine zero is top back right,...
