Separate names with a comma.
Some features disabled for guests. Register Today.
All the relevant videos are here: OpenBuilds Workbee 1510 (60" x 40") These videos should apply of it was purchased from OpenBuilds or an...
Out of curiosity what was your stepover percentage?
It probably may be the limit. A 1/2 inch end mill is removing 4 time the material (roughly: twice the width and twice the depth since you were...
Is it MDF? It is very dusty, and on the rare occasions that I have cut it, it is static prone.
An issue I see, is that you need an extra long endmill to cut through 1.5" material. The longer the endmill, the more flex in the the endmill...
Kodiak Cutting Tools have extended reach endmills in 1/4inch.
I can not remember where that was posted, but it probably cost more to buy the optocouplers and other components and build it then if you can find...
Yeah I have mine set to 600 for the Y. I had it at 400, but when I looked at your file I realized it couldn't hurt to increase it. To Infinity...
This is perfect! I will make one for my wife. Also, since mine is up ad running, I have been inspired to finally finish my Acro. I had issues...
**Warning: Opinion follows which is not based on personal experience :) ** Many people have used the 2.2Kw on Openbuilds machines. That being...
With the router, if you keep the DOC at 1/2 the diameter of your endmill and cut at 2500mm/min (100 ipm) you will do just fine. Depending on the...
If you feel the need for more than one limit switch per axis, then they need to be wired in parallel if they are normally open. Wiring Limit...
I would get the 1010. But if you are still concerned about size email the parts store and ask them to cut the smaller size. That being said, if...
An Arduino Uno can only do 3 axis: X, Y, Z. Connecting Grbl · gnea/grbl Wiki The fourth motor is slaved to one of those axis.
Did you home the machine before setting your XYZ zero point? Did you calibrate the various axis? Grbl v1.1 Configuration · gnea/grbl Wiki If you...
My Pen Engrave-inator (shout out to Dr. Doofenschmirtz) is pretty much done. I just need to install the self-destruct button. But sadly I have to...
If you just want to transfer 2D drawings, save them as a .dxf file.
You can save your Fusion 360 model as a .stl file and import that into Vcarve. That is what I do. For example, I wanted to carve a mason bee into...
I was looking at the picture and was amazed at how clean the wiring is compared to the mess mine is. Then I enlarged it to see where you hid the...
Did you do a roughing pass and then a finishing pass? I usually will do a roughing pass and leave about 0.3 mm for a full depth finishing pass to...
