Separate names with a comma.
Some features disabled for guests. Register Today.
Oh Right I read C-beam and think Ox LOL.. for that big Dual-belt Ox is really the only reasonable way, without going to 12mm screws or rack and...
15000? or 1500? no custom parts needed just cut the rails to the length you need. stock 1000x1500mm v-rail setups give about 820x1270mm cutting...
Andrew, I know on my ox plates it's hard to tighten the bottom two bolt, so the top two are doing most of the work for the Y and X plates. For...
What do you need to know? where did you get them from? Only thing I would say is I can't think of any CNC use where the anti-vibration plate...
I think most people never use reverse and just wire that for forward operation. unless you re-scale the 0-10v input you will never get full RPM...
17.4 :)
David, my genuine Uno ran it no problem, Motgor's xPro has the issue :)
I ran the Celtic file no problem even engraved some MDF. so it's not the gcode. I do not have a CNC xPro, I use Arduino Uno and UGS platform....
what are you using to make you G-code (and the drawing)? try uploading the file here and we can look at it, you might have an incompatible command...
shielded wire is a good idea for steppers Amazon 50 feet you can use this for the spindle, or better is get some shielded 2 conductor for that,...
Depends on the drives
MotGor, Looks like you set GRBL up fine, I can't see the acceleration but everything else should be ok. Make sure your drivers are set for 1/8...
Need more info, are you using UGS? do a $$ command and post here what you see for your settings that's the first place to start and yes this needs...
Kevon, I think he just means he will be using a 250mm C-Beam section for the Z just like the 1000x1000 isn't the travel but the length of the...
Rob, found this pdf attached.. as for the stiffness (Young's Modulus) the paper says G10 is about 19 GPa, best i found was 24 GPa. (here) lots of...
find me a 4m ball screw....? for under $1k
Cool build!
I got my steppers from valuehobby.com, they might get them from steppers online not sure.. $20 will get you plenty of torque on a nema23.. hard...
Did you bond the 2040 to the c-beam? It will help anytime you give your wheels more distance, increase leverage of the carriage and decrease force...
Ok try this one, they have a good selection Aliexpress 12-8
