Separate names with a comma.
Some features disabled for guests. Register Today.
sensored motor and sensored rc truck 1/8 scale esc.. or something like this.. APS 120Amp 2.0KW Sensored single motor E-board DIY Kit - Alien Power...
Is it the new uhmw rack and pinion drive that was teased a while back?
that ESC is only good for about 12v (3s lipo), would need an esc that can do 6s lipo to go up to 24VDC
the MDF is only porous in that way if you take the skin off both sides, and even then the shopvac doesn't make the kind of static pressure you...
Interesting, that motor has very low current for its torque, good find.
I like that you kept your plates simple. I was able to watch the video no problem just download first. You plan on "dual belting"? I'm curious...
why do you want to change the $1? when you say "the whistle stops" is it turning at that point or no? Did you double check that you are connecting...
if you could lightly twist the pairs (from the same phase) together then sleeve the wire in braid to make it cleaner, but shielded 18awg wire is...
Nice build! I fully agree about the unsupported rails. I thought about drilling my own plates but chickened out!
Just found this nice resource.. your vac board design looks ok, i would say you might want to add some shallow grooves connecting the holes or...
Rick has a good point But it depends on the shop vac, if it is a dual stage type with separate fan for cooling it will be fine, most wet/dry types...
Been a slow start!!! after I ordered the Plates, wheels and motors my bathroom jut/remodel project had some cost over-runs, then the roof leaked...
plus and minus doesn't matter all that much.. the motor will just go the wrong way, you can sort that out later (swap any two wires).. is the...
why the YELLING? Mark is busy running this place, all the info is in the build. which I found in 1minute, he's using GRBL and a GRLB sheild....
I know, old thread... I'm right there with you, used autocad for years... has such a great fillet tool, really miss fillets and tangent snaps!...
turned out good for a prototype, couple things I want to change but this is perfectly use-able. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Working on a birch ply F-clamp so far prototype working out well, helped me get more up close and personal with the SketchUCam "join G-code"...
The hex pattern, looks cool, and to spread out the vacuum over a larger area, the torsion box is a vacuum table.
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Got the HEX pattern lined up, still don't know why it was off last night but this morning i re-ran the g-code and it worked great. Thanks for your...
