Separate names with a comma.
Some features disabled for guests. Register Today.
Here is one with a sketchup file that you could probably generate a .dxf file for making tool paths. Scott's Router Table Are you attaching the...
Great motto.
Oops. I also bought a 500mm piece of 2020 v slot for the upright braces.
The most expensive part was the rotary axis. But, If a person went with a smaller one like a 65mm chuck, that waould knock about $100 off the...
Do you mean an arm the holds the knife that does the carving? I think the easiest is to do one similar to mine. Then you are not limited to just...
I don't know the exact amount. I purchased the High Z modification for the Lead 1010 then purchased extra extrusions and screws. However, I...
I would buy a smaller chuck than I did. I bought a 100mm chuck, but if I were to do it again, I would purchase a 4 jaw 65mm if one could be...
You will not go wrong by following the instructions here: docs:blackbox:start [OpenBuilds Documentation] That is what I did, and I have never had...
There was some hinting awhile back. I think OpenBuilds is behind all the new "ufo" sightings lately to distract us from their real secrets. The...
I switched from sketch up to Fusion as well. Fusion is way easier and more intuitive in my opinion (and probably the OP's). I would not say I...
You do not have to home between tool changes. You just have to rezero the z axis. Another thing I do for a long cut like a 3d carve is I home,...
I had a similar problem where about 50mm from the far extreme positive end it would stall when going back towards s the o point. In my case the...
Yeah, I feel acceleration is more critical than max speed for me. Vcarve tells me a job will take about 1 hour and 20 minutes. When I actually...
It is probably your acceleration settings for that 6950mm/min speed in a hairpin turn. It is trying to get up that speed in a short distance....
It is probably your acceleration settings in GRBL. For example, I had slower acceleration and my lathe could easily go 4500mm/min. I increased...
I was trying to decide on a controller that can do a rotary axis with Lightburn without having to swap wiring from one axis to another and then...
First you need to figure out what space you loose no matter what you try. 125 mm for the x gantry. 40mm x 2 for the y axis cbeams. At...
I needed a place to store the old (circa 2011) Windows 7 laptop. All unnecessary software was removed. It only functions as the CNC controller....
Do you need a precision lead screw? Metric sized shaft couplers up to 12mm are easy to come by and a cheap 12mm threaded rod and nut are easy to...
Were they 1605s? Those only move 5mm per rotation. That is almost half what the lead screws from OpenBuilds will move your gantry and are about 4...
