Separate names with a comma.
Some features disabled for guests. Register Today.
I have milled only one PCB in my life and I have to say FlatCam made it easy.
I am pretty sure the problem lies in your pirated software and not a legitimate Vectric product. I use a high speed gaming laptop with a GPU and...
As mentioned above by jeffmorris, end mill diameter is important. Not all end mills are the diameter they claim to be. Most I have purchased...
Try a small project at 1500mm/min. I bet it will do just fine. Then speed it up a little more until you find its limit.
No, that probably was not the cause. Amine blush is a surface problem that really is only a problem if you are building a boat and have a busy...
I can't answer here because I am only allowed 420 characters. I sent you a message.
Judging by the first few lines of your Gcode your feed rate is only 800mm/min (F800) and plunge rate is only 228.6mm/min F228.6). I cut aluminum...
Amine blush perhaps. West Systems is great at forming amine blush on the surface which normally is a bad thing. It can prevent layer adhesion and...
If you mean the video for calibration, this is it. [MEDIA] The Vcarve postprocessor is here down the page a bit under "VCARVE JOB SETUP": Rotary...
Just to complicate things, I use both. I use Vcarve for doing 3D carving of models I find on Thingiverse and on rotary carved objects. I use...
There is a post processor for vectric Vcarve that converts mm to degrees of rotation when using their software. That is what I use on my newly...
You need to calibrate each axis and OpenBuilds Control has a calibration wizard to assist you.
So far, I have cut several items with my newly built lathe based on a LEAD High Z kit to get it dialed in accuracy-wise and to test limitations....
I was going to suggest contacting their customer support, but that refers you to a forum that last looks like it was used in 2019 and I see you...
Free cnc router software downloads for our Drag Knife It was under the software tab on the donektools.com website.
Sounds like you have it right to me.
Howzabout sealing the wood with epoxy first before cutting? I have built a fleet of cedar strip canoes and kayaks (and one pirogue) and I always...
I am not sure I understand your question. The z limit is put in a position to mark the top of the z travel for homing. If you do not have the...
It can be done, but you would loose features with only the two wire connection.
It still sounds like a wiring issue, especially when it was just modified. Is there any chance that there is a bad connection in one of the screw...
