Separate names with a comma.
Some features disabled for guests. Register Today.
What are your $110-$112 settings? In grbl that is where you set the maximum speed allowed. If it is set to 160" per minute you will not be able...
lining up is easier with using dowels and pre cut holes.
You can run full sheets through using toolpath tiling.
I was looking for yours, but looked in the wrong spot. Thanks for repointing it out.
Have you already homed the machine? gnea/grbl
The LEAD 1010 is a newer more modular system that does not need the larger gantry plates and uses less wheels. I believe it should have a larger...
And if you buy that top for a five gallon pail that showed up in JustinTime's link and put it between, you get a great cyclone that saves your...
I use 18000 rpm at 2500 mm/min at a cut depth of 1/2 the diameter of the endmill. HDPE is one of my favorite things to cut because it is so easy....
I am sorry to hear that. Hopefully it can get sorted out quickly.
Also I noticed the power supply is 40V. The BlackBox needs 24V. So if you went the Blackbox route, then a 24V power supply would be needed....
Go through this process here to include the last step. There may have been damage. You may be at step 6.3.6....
No. Openbuilds designs their parts using SketchUp I believe. There are also other CAD types. The person that made the .step files did so before...
Do you mean RPM or feed rate? I use 2500mm/min and 1/2 the diameter of the end mill for the depth of cut for both of those materials. For my...
Yes, this could mess up your XYZ zero point because of missing steps. Whenever you have a "crash" of some sort, assume you lost steps because the...
Yes. There are a whole lot of steps to go through. I am not trying to put down Fusion360. I love it and use it nearly everyday. The fact that...
It is too bad Vcarve doesn't work for a Mac. It is so user friendly. I can drop an .stl file from thingiverse into my stockpiece, generate tool...
All OpenBuilds parts are available at the 3d warehouse in Sketchup. [ATTACH]
If your spindle is square with your X axis (in both directions), then the x axis could be lower on one side and you would still be ok because once...
Bigger screws are definitely a good idea. I stuck with the M3 size, but I remove the set screws and use socket cap screws and loctite. I also...
You may have to loosen the spindle mount screws and twist and shim. On my new lathe I built, I had to shim an axis, and I was lucky that two...
