Separate names with a comma.
Some features disabled for guests. Register Today.
I had to choose the Old Boot loader. Not sure how this affects xloader - if at all. I only had the problem after updating my IDE which was a...
MG, I had the same problem with a nano a while back. There is two nano versions on the IDE. I can't remember what differentiates them. I am not...
If the 15 mm are used to bolt plates to the ends of extrusion beams, they should work fine.
That should help a lot. But do you need it that high? If you are only cutting sheet goods, I would lower the whole High Z mod and your original...
One problem is that as you move your axis around, or up and down, the steppers act like generators and produce electricity which can damage your...
The first picture is not an Openbuilds extrusion. What video are you referring to? It would be very simple to replicate either of those in...
Compare the measurements of the slot specs to what you have on the 8020. The slot width of the OpenBuilds V-slot linear rails (C-Beam and all...
I do 2500mm/min with a 2 flute straight flute 6.35mm endmill using the same parameters as Alex (DOC for wood and soft plastics = 1/2 endmill...
I feel so guilty - or lucky - when I see you repeatedly tell people this. My USB cable is 10 feet long and I have never had a problem. :) But I...
I think this would be tough because you would need to create a negative image of the item you carved unless it is a simple 2.5 D carving such as...
I have the same drivers with less powerful stepper motors and my screws move the gantry 12.7 mm per revolution. I use the 1600 and I easily cut...
Looks good! Better than my first unintentional attempt at stainless. It was a piece mixed in with aluminum off-cuts at my local metal yard...and...
You could always lower the entire x axis if you do not require the total height most of the time. I am modifying my custom built CNC with the lead...
If you are going to try to build something 72" you will jump up greatly in expense because the larger lead screws are expensive and there are...
If you set your Z zero to your spoil board, you will always cut through the work piece.
I think all he did was come here and post it then leave. He hasn't been back for over 24 weeks. He says how to figure out how to reconstruct it...
Try using a straight flute endmill/router bit. I use only double straight fluted endmills for wood and I do not get tear out/rough edges. You...
I would think that all you would need would be the higher sides like the 300mm you suggested. Z axis should be fine at 250mm. I have a 250 mm on...
From what you are describing, it sounds like something is mis-wired. What happens if you jog your x axis? Does Y move? docs:blackbox:start...
Weirder yet, when I open the .dxf I created from the original .svg that was posted above in Inkscape and save it as an .svg, it works just fine....
