Separate names with a comma.
Some features disabled for guests. Register Today.
Big update! [ATTACH] You vs the guy she tells you not to worry about. [ATTACH] I opted for the lightweight variant for the gantry beam and boy...
Shielded cables are not all made the same, but at the same time, it's kinda hard to screw up. Double shielding is a combination of foil and a...
You can easily find long length end mills. You don't need a larger diameter to achieve that. A 1/4" long length end mill can still handle enough...
What exactly do you mean by burn stains? Cleaning material build up depends on the material you were cutting. If the end mill is discoloring,...
Before, the limitations were computer/electronic, not hardware. With an ATC, the limitation is hardware. It will get easier for sure, but...
Ya. Waaaaay too much. There is a lot that goes into an ATC.
Do not run it at 1000rpm! Also, that list technically says 1rpm to 18k/24k rpm. The spindle can run at whatever rpm it is driven at. The VFD is...
I use 16/4 double shielded on my 2.2kW. It's not cheap, but does give a piece of mind. I used different sizes of this stuff for everything on my...
That does appear to be a legit unit with angular contact bearings. I just got to play it. The whine you hear is the electrical current, but you...
What spindle do you have? There are a million different variations. I'm not by my pc to rename the file and won't be anytime soon, but is this...
Ah, I'd say to go with a wider angle tip like these. Your spot should be wider than your actual drill. LakeShore Carbide.com Carbide End...
It's a heat issue. You NEED some form of active chip evacuation and cooling if you want to drill that deep and that many holes. Heat builds up...
It's a relatively large screw driven printer. It will be precise, but slow. Do you have any specific questions?
An idea just pooped in my head and didn't clean up after itself. Unlike some of the Arduino based options that can be built on, none of the...
If they are NC, let them share a ground wire. The other two would be for either travel limit. Remember to only ground one end of the shield....
If you need something a little lighter duty than Rob's. Ultimately, it depends on what you want to spend, how much work you want to put in, and...
One thing to pay attention to is the canopy edge gap. I wouldn't hurt to actually make the canopy frame slightly smaller than it's intended spot....
Instead of pecking, you can interpolate (circular ramp) holes slightly undersize, then follow up with a finishing pass. When you do this, you can...
I've noticed that all "20" sellers happen to be the same person with only a single tube as when one sells, they all go out of stock together. Now...
Well that hurt like heck. I've been putting it off for too long, but the extrusion is on order. It probably would have been 30% cheaper to go...
