Separate names with a comma.
Some features disabled for guests. Register Today.
I purchased two 50x15mm (inner) cable chains, but will only need one. The spindle and VFD are genuine Huanyang products. It's a 220V 2.2kW (3hp)...
The wire that I got for the steppers was nice, but would not work for this application. I have a smaller 18/4 version of the same type of cable...
The HY 2.2kW spindle and VFD are on order! I also forgot to link the end stops. Goals for the enclosure: - flood friendly - vibration isolation -...
Hi. ☺️ As seen, it weighs 64lbs. It will be right at 100lbs when complete. Then I still want to add the sand filling, but that will wait till...
The one thing that @Peter Van Der Walt has been trying to point out is that these frames just can't handle what the larger spindles are capable...
I've been playing with it off an on. I switched back to the Phoenix since I know it at least got me past homing. I even tried OB Software as...
A simple 2 flute down spiral for ply will eliminate fraying. Balsa is more of a struggle to hold down, but you don't have to worry about...
The version that's on it is 1.1g. (The Phoenix was running on 1.1e.) I've been trying to see if I can redo the flash, but I can't even add the...
That would have been mind blowingly amazing if that was it, but sadly there is no continuity. I actually started at 250ms, but dropped it after...
$0 - 10 $1 - 255 $2 - 0 $3 - 0 $4 - 0 $5 - 0 $6 - 0 $10 - 1 $11 - 0.020 $12 - 0.002 $13 - 0 $20 - 0 $21 - 1 $22 - 1 $23 - 0 $24 - 50.000 $25 -...
I'd say the greatest headache by far has been the software/electronics side. I switched from the Phoenix due to it constantly disconnecting, to a...
The tolerances are only as good as you build it.
Before anyone says that's expensive for what it is, it really isn't. Custom work is always a bit more for a few factors. 1) Custom doesn't fit...
What I do it a 0.5mm pass as fast as it can without bogging down, then a lighter 0.2mm skim. If the load is too high, the Z axis will actually...
It's been available in black though.
Which axis is the flat spot aligned with? You more than likely have backlash.
I just use this 20/4 jacketed wire. It isn't shielded, but that hasn't shown to be an issue.
Yes, something is missing. Your control software has zero impact on anything. This is all decided in you CAM package. This "helix toolpath" is...
This escalated quickly. Go on. *grabs popcorn*
Your gantry is too tall. It's creating a fair amount of leverage.
