Separate names with a comma.
Some features disabled for guests. Register Today.
Estlcam is the same way. I just open the .NGC file and save it as .NC and it works every time. Nothing gets changed.
It depends on what controller software you are using. I use Estlcam and it is pretty straight forward and there are video tutorials on how to do...
Yup. Torque.
I do not have pictures. However if you Google information regarding shielded wiring there is a lot of tutorials and explanations on how and why...
Did you check your spam folder in your email for responses? For some reason, that is where the Openbuilds emails automatically go in my gmail...
It looks like you are pretty dialed in, but here are a couple suggestions: Here is a simple 2 plus minute video - math included - on calibrating...
Did you ground the shielding on the cable? Are your signal wires (limit switches) shielded and grounded?
I need to check with my kids first. We did not use it last year, but I would hate to sell without asking them first
My y axis gantry - with the spindle and everything - probably weighs about 20 to 25 pounds and rides on 8 wheels. 4 on each side. I don't know if...
You can get 1/4- 20 nylon screws and nuts at big box stores like Lowe's or that other one where the customer service sucks and no one is ever...
I have one I may be willing to part with. I can even reprint the parts with a better printer. I hadn't responded earlier because nowhere in your...
The vslot linear rail is on sale now. I would use this as a go by and mount new x and y rails that will last for a very long time using the proper...
Wow! I thought I loved my coffee. This takes it to a whole new level.:thumbsup:
I use a variety of ways to do it. I have clamps for my t-slot which I did like in the picture above, but for small stuff I use the blue painter's...
I have a set of 2. I know my frame is square so I just jog my y gantry up close to the front plates the screws are attached to then I insert the...
Are these the types of cables you are looking for? Electronics - Cables - OpenBuilds Part Store
It has been a while since I used Fusion to generate gcode. Is there a way to not select any compensation? I do not recall ever using any...
Also, if you need a perfect fit, measure the endmills you are using on the cutting surface. Most are actually slightly smaller than what the...
I had a similar problem when I first started using it. I selected the wrong microstepping and was making everything twice as big as it was...
To be totally honest, I installed all my limit switches and never got around to hooking them up. They would normally be for safety and homing....
