Separate names with a comma.
Some features disabled for guests. Register Today.
This is just to help reinforce the idea. This is with a 2.5" end mill. My bed is raised by 40mm and uses a ~10mm spoiler. In fact, 3/8" (10mm)...
I was wondering the same, but for 1/4". I haven't gotten a chance to try the generic surfacing routing bits yet.
From the pictures, I noticed how low you have the router. Raise it up a bit. This way, the end mill can clear the bottom of the gantry. I'd...
My machine has been running for about 4 months. One driver was DOA. Today, another may have bitten the dust...in the middle of a job. That's a...
How thick is your material? What post processer are you using? It's plunging to a full 16.7mm, which is an odd number for any material thickness.
The vslot is actually cheaper than most equivalent extrusion.
It doesn't matter which wire goes where. All it is doing is closing a loop. One wire goes into one port and to the base of the probe. The other...
Here is the original, but there are quite a few active models on the very first page on the forum right now. C-Beam cnc Cutting something smaller...
That probably would have taken 15 minutes by machine. How large of a cutting area do you need? If you need anything above 24" of y travel, then...
Ya... That's a negative Ghost Rider. What do you plan on cutting? I've thought about using 4040 on X with 2060 on Y with a small ~300W spindle....
All of that quietness changes when the end mill touches material. Don't put your money on the volume of the machine itself.
At this point, I'm just talking to myself, but someone may find this useful. Toolpaths are an amazing thing. I went from that limit with a...
For what you described as a goal, I firmly believe the Rick's design is a much better option,which is actually what I was trying to reinforce in...
The limits have been on for a little while, but I only recently completed the setup. I now know what my life was missing. I also used the limits...
You say it holds no weight, but weight is not the enemy. The enemy are the forces created during cutting. once you apply a load pushing or...
I agree with you for two reasons. 1) No matter how you set it up, your leverage point will remain the same. But one method attaches more weight...
You're better off keeping the stronger structure closer to the cut. Right now, the 2040 is being supported by the 4080. It should be the other...
No problem, just let us know how it goes.
ENTIRE POST EDITED: According to your picture, your axis are labeled wrong. Your x should be side to side, not fore and aft. You're going...
I started a thread in the controller section. Controller Disconnecting with Flood Activation I'm having some issues with the coolant feature....
