Separate names with a comma.
Some features disabled for guests. Register Today.
You don't seem to know what direction you actually want to go. Unless you want to spend more than a new car, you're not going get a 5 axis...
I'm pretty sure it's all the same, but my question is, does it matter? It's all framework based on external dimensions. All supporting/accessory...
New product idea: I opted to go this route instead of buying a bunch of brackets for obvious reasons. It consists of a lot less parts (including...
1/4" and 6mm may look close enough, but I wouldn't dare putting a 6mm shaft into a 1/4" collet. You may be able to get away with it for 1/8" and...
I didn't realize that GRBL Panel had macros. :p Now that only leaves the 5v for the limit filter.
I haven't made an update in a while. Today, I tore the machine down and cleaned it up. First step was removing the flood tray. It unfortunately...
Cutting acrylic on a CNC is a piece of cake. When dealing with plastics, heat is your enemy. To help with that, you want to remove chips. An...
1) None of those materials should be a problem provided you use the proper cutting parameters and endmills. 2) For two sided cuts, focus on your...
They are endmills, not bits. What type you get depends on what you need. I would never use my aluminum cutting endmill in wood, or my acrylic in...
Was a bit occupied earlier. What I meant was that you should not put crazy side loads on the motor's shaft. It will destroy the bearings which...
You shouldn't place lateral forces on any kind of motor. A spindle/router is barely an exception.
One has a moving gantry. The other has a moving table.
Delta settings: Max feedrate It doesn't matter what command you give it if you have it set to not exceed 200mm/min.
You cut. 27mm doesn't exist. The alternative is a 3/16" plate with 25mm, or a 5/16" with 30mm.
I'm curious as to why you strayed from the 23 that it was specifically designed for? Unless you plan on cutting foam, you're really not going to...
I second the "bottom cleaner" end mill. I use a 7/8" (22.225mm) at 2000mm/min with very light passes. I try to remove as little as possible. I...
I got to leak test everything today. I forgot I left some holes exposed under the mounting rails. I'll just make tiny block off plates and apply...
I made some supports for the flood tray. I'm just waiting on my buddy to have time to build the stand. It will all be cut on a much much much...
Do you have the steps set on the driver AND steps/mm in you controller settings?
I've sent an inquiry to Chris about the base plate. A single 1/4" aluminum plate topped with a sheet of hdpe should do the trick. I could even...
