Separate names with a comma.
Some features disabled for guests. Register Today.
I surface my spoil board and always leave a lip on the y axis edge. I know that when I place material - or spacer blocks to align material- along...
This is beautiful! Do you have a link to the etsy store?
And if you don't hear from them check your spam folder. It happens a lot when people say that OB has not answered their email that the spam...
Are the drivers overheating? This would happen with some of the lower amperage drivers if not cooled well. I am not familiar with the vapor board.
For doing the dolphins, I would consider getting vcarve desktop. Estlcam will also mill from .stl files. If designing them yourself, maybe...
I do not believe you can use a .dxf for a 3d object unless it is a flat plate. I use .dxf for pretty much everything I do, but it is all 2.5 d...
I built an enclosure form my printer with a Lack table. I used dollar tree foam board (black) for three sides and then put an acrylic door on the...
I am curious if you have a 3d printer? if so, I have a suggestion that would require an IKEA location near you.
TB6600s can be unreliable and sometimes not even real TB6600s. People have found different chips when they have opened them up. I have some from a...
I doubt it since it does not appear to be open source. But they are not hard to copy.
Are belts that much cheaper? When I built my custom designed CNC, I considered both dual belts on each side vs 1/2-10 5 start precision acme...
Yes. You need either the drivers installed, or the Arduino IDE software which contains the drivers. I switched computers once and it took me a day...
I was going to "sticky" it, but I don't know where my authority as a mod begins and ends. ;)
It does look like it is starting in a different spot each time.
However, some of the pins have changed on newer versions of GRBL compared to when the CNC shield V3.0 was designed. gnea/grbl
Maybe this has been asked before, but are you doing a finishing pass on the medallions? It is weird that they show up opposite of each other....
I think for most people, there is a free solution available. Until I decided I needed a rotary axis, I was able to everything I wanted to do in...
I have avoided paying for software other than Estlcam, but that Vectric Vcarve Desktop has some great capabilities for a rotary axis. I may be...
I would think that If you are happy with your current stepper motors, you would not have to upgrade. All you are doing really is increasing the...
You could modify your end plates and get 1/2"- 10 5 start precision acme screws from McMaster-Carr. You would need different bearings and...
